Power Probe 3 Master Combo Kit PPKIT03S
PPKIT03S
Product Colors
The Power Probe 3 Master Combo Kit combines the Power Probe 3, PPECT3000 and various accessories to provide the ultimate combination of diagnostic and circuit testing capabilities. The Power Probe 3 provides simplified testing of Motors, Lights, Relays, Sensors, as well as supplying Power and Ground for functional component testing on or off the vehicle. The PPECT3000 will help you trace short and open circuits quickly and accurately.
Authorized Resellers
The PPKIT03S Kit includes:
(Click on the items below for more information)
- Power Probe 3
- Power Probe Tip
- Battery Clipset
- Cigarette Lighter Adapter
- 20ft Extension
- Large Piercing Probe
- Small Piercing Probe
- 4MM Male/Male Adapter
- 4MM Female/Female Adapter
- 1ft Lead
- 3ft Lead
- 6ft Lead
- 3 Light Bulb Adapters
- Universal Adapter
- Alligator Clip Adapter
- Blade Probe Adapter
- Back Probe Adapter
- ECT3000 Transmitter
- ECT3000 Receiver
- AAA Batteries
- Need just the Power Probe 3?
- Looking for the ECT3000?
Features:
- Voltage & Polarity testing
- Continuity testing
- Activating components out of the vehicle’s electrical system
- Activating electrical components in the Vehicle
- Activating electrical components with ground
- Testing trailer lights and connections
- Checking for bad ground contacts
- Red/Green Indicator & Audio Tone
Specification:
- DC 0 to + 70V +1 Digit
- P-P 0 to + 70V
The frequency response of tone pass through - 10Hz to greater than 10 kHz
PP Display - 15 Hz Square Wave
- 35 Hz Sine Wave
Power Probe Mode – Continuity to ground - First level – Display is enabled less than 20 K Ω
- The second level – Green LED is enabled less than 600 Ω
– & +Peak Detector Response - Single event capture less than 200ms pulse width
- Repetitive events less than 1ms pulse width
Peak to Peak Mode - 0 to + 70 + 1 Digit
- 4Hz to over 500kHz Square Wave input
- 4Hz to over 250kHz Sine Wave input
- The threshold for PPAC/Audible passthrough
- Circuit Breaker 8 amp thermal response – Manual reset
Typical Response
8 amps 10amps 15amps 25amps Short Circuit
No Trip 20min 6 sec. 2 sec. 0.3 sec.
- Trace Out a Short Circuit to Chassis Ground
- Tracing Out a Battery Drain or Current Draw
- Isolate your Circuit
- Verify the Short Circuit to Ground
- Verify an Open Circuit
- Short Circuit inside a wire harness
- Reception Distance from 1 inch to 8 inches
- Tracing Circuits that are shielded (Plastic Panels, Pillars, and Carpet)
- Shut off time is now 10 mins
Transmitter Spec
- Min Operating Voltage 8 VDC
- Max Operating Voltage 48 VDC
- Working Current: 200mA
- Working Frequency: 4KHz
- Max Operating Relative humidity: 80% ( Non-condensation)
- Max Storage Relative humidity: 80 % (Non-condensation)
Receiver Spec
- Power Supply: 2 x 1.5V AAA
- Working Current: When a signal is not detected <15mA
- Power Consumption when power off:<10uA
- Max Operating Temp: 50°C
- Max Storage Temp: 70° C
- Max Operating Relative humidity: 80% (Non-condensation)
- Max Storage Relative humidity: 80% (Non-condensation)
Kit comes with a CD
